CO2 Jet Machine

Specification

FUNCTION

*Column Height：8-10(m)

*Adjusting Angle: 90 degree

*Control Mode：DMX-512, Manual

*Without LED Ring

*Package Included: Power cables, jumper power connectors(without cables, you can DIY different length jumper cables), 2 meters DMX cables, 5 meters length high-pressure Pipe（not included CO2 cylinder, buy in your local）

CONTROL & CONNECTIONS

*  (1) DMX Channel Modes (7 channels)

*  Digital Display

*  3-pin DMX In/Out

*  PowerCON Power In/Out

*  DMX control, Manual

THERMAL & ELECTRICAL

*  Input Power：AC 110V or 220V, 50-60Hz

*  Power Consumption：70W

*  Working Pressure: 5Mpa

*  Co2 consumption Rate: 0.35kg/S

APPROVALS / RATINGS

CE | RoHs Compliant | IP20

SIZE / WEIGHT

*  Net Weight: 15lbs (6.8kg)

*  Machine size: (17.7"x 13.8"x11.8") 450x350x300mm

Operation Instruction:

1. Put the fixture on the flat surface and installed it in a fixed place. There

are 4 plastic corners on the bottom of the fixture, need to take them off

and use the screws to install it strongly.

2. 4 units can be connected in series via special pipes and DMX512 cables

If you choose manual control, put the button “ON”, but please note that,

you choose this mode, after turn on and then need to turn off to

close the valve, otherwise it will project CO2 continuously.

3. You can adjust the height of projecting of CO2 by adjusting the

switch of charging bottle

4. After using, please let the machine project all CO2 inside of the

machine and then turn off the switch (it is better put it on the

OFF) and close the switch of the charging bottle

Back Panel Instruction:

DMX: In DMX512 control mode (after 3 seconds, reposition to

close the valve)

OFF: Close (operation switch)

ON: Manual switch for valve