Views: 0 Author: Site Editor Publish Time: 2022-03-30 Origin: Site
The use of LED-Based Moving Lights can ensure the uniformity of the picture light, which is very suitable for background dyeing in multi-function halls and studios, and the colors are dazzling and mixed evenly.
How to install LED-Based Moving Lights?
What are the following steps of installing LED-Based Moving Lights?
What kind of LED-Based Moving Lights should I choose?
Process flow:
Lamp stand, LED-Based Moving Lights installation→matching down-lead→light test
LED-Based Moving Lights installation:
Measure the installation height of the lamp (light stand) according to the design requirements, and draw a mark on the pole.
Hang the lamp holders and lamps on the poles (heavier lamp holders and lamps can be hoisted on the poles with pulleys or large ropes), wear the hoop or bolts, find the illumination angle according to the design requirements, and find the levelness After that, fasten the lamp holder.
The elevation angles of the lamps installed in a row should be consistent and neatly arranged.
Connect the down-lead wire: fix the pin insulator on the lamp holder, tie one end of the wire back to the insulator, and connect to the lamp cap wire and the fuse respectively. The rubber cloth and black tape are overlapped with one layer each. Then, the other end of the wire is tightened and buckled with the street light trunk line for winding connection.
The phase wire of LED-Based Moving Lights should be equipped with a fuse, and the phase wire should be connected to the center terminal of the screw cap.
The distance between the connection point of the line and the street light trunk line should be 400~600mm from the center of the pole, and the two sides should be symmetrical.
There should be no joints in the volley section of the down conductor, and the length should not exceed 4m. If it exceeds, a fixed point should be installed or a steel pipe lead should be used.
Soft plastic pipes should be covered at the places where the wires enter and exit the lamp holder, and they should be made of waterproof bends.
Test lamp: After all installation work is completed, power on, test the lamp, and further adjust the illumination angle of the lamp.
LED-Based Moving Lights should be used with a transformer when using LED-Based Moving Lights. The lamp beads should also be of good quality, otherwise the lamp beads of the spotlight are easy to break.
The quality of LED-Based Moving Lights on the market varies from good to bad, and it is difficult to distinguish between good and bad with the naked eye. Therefore, it is best to choose branded products when buying LED-Based Moving Lights and choose high-quality transformers that match them.
PROWALLS has been a Chinese pioneer in LED-Based Moving Lights for several years. They understand that each application is special. Their knowledgeable staff can find the best solution for any scenario, particularly when a custom product is required. You can get what you what you want at there.
